Current time: 09-25-2020, 05:12 PM Hello There, Guest! (LoginRegister)

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
When navigated to multiple pages through WPT script, what would be the final result
09-11-2014, 12:30 AM
Post: #2
RE: When navigated to multiple pages through WPT script, what would be the final result
It depends on how you write the script.

If you use the "combinesteps" command at the beginning then it will merge all of the pages into a single sequence and the result will be the time for the whole flow.

If you use "logdata 0" and "logdata 1" then you control the step that is being measured (usually the last one with the earlier steps being used to set up cache and state).
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: When navigated to multiple pages through WPT script, what would be the final result - pmeenan - 09-11-2014 12:30 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)