Current time: 10-15-2019, 02:03 PM Hello There, Guest! (LoginRegister)

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Full load time reg.
09-15-2014, 03:28 PM
Post: #1
Full load time reg.
Definition:The Fully Loaded time is measured as the time from the start of the initial navigation until there was 2 seconds of no network activity after Document Complete.

Is it possible to increase/change this 2s time period, as my test loads a document and the network inactivity period between the initial page and the doc to load > 2s. So the the webpagetest completes even before the document loads fully
Find all posts by this user
Quote this message in a reply
09-16-2014, 03:46 AM
Post: #2
RE: Full load time reg.
You can control this by setting minimum test duration, it's on the advanced tab

Andy

Using WebPageTest - http://usingwpt.com/
Visit this user's website Find all posts by this user
Quote this message in a reply
10-16-2014, 06:55 PM
Post: #3
RE: Full load time reg.
I could set the minimum test duration (run test for atleast) under the advanced tab. What is the corresponding parameter in the restFul API?
Find all posts by this user
Quote this message in a reply
10-17-2014, 01:18 AM
Post: #4
RE: Full load time reg.
"time"

If there is ever a feature in the UI that the API parameter isn't documented you can just inspect the form element to get the "name" of the element which will be the API parameter to use. The UI uses the API so everything you can do in the UI can be done through the API.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 2 Guest(s)