Current time: 12-15-2019, 01:00 PM Hello There, Guest! (LoginRegister)

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Mobile Agent Setup in MAC - relayServer
02-18-2016, 01:25 PM
Post: #11
RE: Mobile Agent Setup in MAC - relayServer
(02-18-2016 01:48 AM)pmeenan Wrote:  Can you run it with the debugging enabled (-m debug)? That will provide a lot more detail about what is going on. I think the wpr and ipfw errors can be ignored. Those look like they are probing to see if either is enabled/supported.

Can you also try this from a shell prompt?

Code:
adb shell
su -c 'echo x'

It's possible that something is going wrong with the shell parameter passing in the shell on OSX (I've only tested the adb control on Windows and Linux) but it should be fine.

Hi Patrick,

If we run adb shell and su -c 'echo x' as separate commands it is printing x but if we give in single command as adb -s 568cf8dd shell su -c 'echo x' - it is giving error as "Unknown id"
Find all posts by this user
Quote this message in a reply
02-24-2016, 01:24 AM
Post: #12
RE: Mobile Agent Setup in MAC - relayServer
Could you open a github issue to track it if you don't mind so I don't forget? https://github.com/WPO-Foundation/webpagetest/issues

I'll see if I can track down a mac to debug it on (I only use Mac's to drive iOS testing right now so the android/adb side hasn't been tested much there).
Visit this user's website Find all posts by this user
Quote this message in a reply
04-13-2016, 12:21 PM
Post: #13
RE: Mobile Agent Setup in MAC - relayServer
I have the same problem.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)