Current time: 11-16-2019, 09:54 AM Hello There, Guest! (LoginRegister)

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
wptdriver.exe - How to configure a log file?
10-18-2011, 05:28 AM
Post: #1
wptdriver.exe - How to configure a log file?
urlBlast.ini can be configured to produce a log file via a line similar to this line:

Log File=C:\webpagetest\somefolderpath

As for wptdriver.ini, can a log file be configured as well?
Find all posts by this user
Quote this message in a reply
10-18-2011, 06:20 AM
Post: #2
RE: wptdriver.exe - How to configure a log file?
Not yet. A lot of the pieces are in place but we haven't wired up the last little bit (actually logging to the file).
Visit this user's website Find all posts by this user
Quote this message in a reply
10-19-2011, 01:40 AM
Post: #3
RE: wptdriver.exe - How to configure a log file?
The wptdriver.ini.sample file contains this line:
;debug=1

Does wptdriver.exe support debug output yet?

Given that wptdriver isn't producing a log file yet, debug output is most likely not supported yet as well but I wanted confirmation of this just to be sure.

Thanks.
Find all posts by this user
Quote this message in a reply
10-19-2011, 01:57 AM
Post: #4
RE: wptdriver.exe - How to configure a log file?
Nope, that is part of the plumbing that is in place but not enabled yet.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)