Current time: 01-23-2021, 12:04 PM Hello There, Guest! (LoginRegister)

Post Reply 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
redirects confuse FF-measurements
02-25-2012, 03:08 AM
Post: #12
RE: redirects confuse FF-measurements
we're using wpt version 2.5 with your agent-patch and we know observe another failure of the same FF-Job (see above):
Approximately every 60 job-runs doc ready- AND fully loaded-time are about 0.1 seconds and the result doesn't contain any request-data at all. Screenshot shows our wait-page. The Measurement stopped after onload-event of first html-request apparently. Interestingly that happens either in first view (measurement of second view OK) or in second view (measurement of first view OK than).
Regards, Nils

Attachement shows a result with failed first view-measurement.

Attached File(s) Image(s)
Find all posts by this user
Quote this message in a reply
Post Reply 

Messages In This Thread
RE: redirects confuse FF-measurements - nilskuhn - 02-25-2012 03:08 AM

Forum Jump:

User(s) browsing this thread: 1 Guest(s)