Current time: 02-26-2020, 02:55 PM Hello There, Guest! (LoginRegister)

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
wpt stops measuring before page is fully loaded
07-08-2013, 10:34 PM
Post: #2
RE: wpt stops measuring before page is fully loaded
WebPagetest will generally wait for 2 seconds of no network activity after the onload event before it considers a page done. It looks like the pins may load after the load event and are loaded by ajax so if there is a delay before that happens then the test will end before they get loaded. You can force it to wait by setting a DOM Element for it lo look for in the advanced settings (assuming the pins have a unique DOM element). In that case the test will keep running until the specified element shows up on the DOM (if there is a specific network request you can also tell it to wait for a network request instead of a DOM element).
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: wpt stops measuring before page is fully loaded - pmeenan - 07-08-2013 10:34 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)