Current time: 02-25-2020, 08:41 PM Hello There, Guest! (LoginRegister)

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Looking for documentation
06-23-2014, 10:50 PM
Post: #3
RE: Looking for documentation
First of all thanks for the answer.

About auth, this is for protect the results in the test only. It's possible to block the access to the gui? since we installed the instance somebody is launching tests to porn websites, etc. We want to protect it but if we use the apache auth we have problems with agents.

(06-23-2014 10:24 PM)SundeepPundamale Wrote:  Navigate to Advanced Settings > Auth(Tab) you can enter the Basic auth credentials there.

To enable tcpdump, navigate to Advanced Settings > Advanced(tab) and enable Capture network packet trace (tcpdump) and then execute your test. You will find the captures in the test result page next to the waterfall thumbnails. To analyse the packet captures use your favourite packet analyser (I am using Wireshark: http://www.wireshark.org/).
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Looking for documentation - miquelangeld - 06-23-2014, 05:40 PM
RE: Looking for documentation - miquelangeld - 06-23-2014 10:50 PM
RE: Looking for documentation - pmeenan - 06-24-2014, 02:31 AM
RE: Looking for documentation - dfreeman - 06-18-2016, 09:38 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)